Manualshelf

Users Manual Part 2

ManualsBrandsShenzhen Snapmaker Technologies ManualsElectronics1600mW Laser Cutting Module
16171819202122232425
CNC Carving
86
|
Quick Start Guide
|
87
3.
Place the calibration card or a piece of A4 paper between the CNC bit and the material. Keep adjusting the
height of the CNC bit using Z-/Z+ buttons until there is slight resistance when you pull out the calibration card,
and it should be wrinkled when you push it forward. Tap Set Work Origin.
5.3.3 Clean the Finished Work and the Machine
Guides & Pictures / Snapmaker
Wrinkled Calibration Card
4.
Tap Z+ to lift the CNC bit until it is above the clamp set, then tap Run Boundary to check if the work origin is
proper. If part of the boundary runs beyond the material or the CNC bit runs into any portions of the machine,
reset the work origin and run boundary again.
If you have run boundary with the CNC bit above the clamp set, you can lower the CNC bit to
run boundary again as you need.
If the CNC bit runs into any portions of the machine, power off the machine immediately and
check if the CNC bit is damaged. Change the CNC bit if it is damaged.
5.
Tap Start to start carving.
1.
Remove the clamp set from the CNC carving platform.
2.
Clean the finished work and the machine using the dust collector, then remove the finished work using the
Diagonal Pliers and complete theassembly.
0.1 mm
Slight Resistance