Users Manual Part 2

CNC Carving
84
|
Quick Start Guide
|
85
If you need to adjust settings, you can either tap Adjust Settings on the Preview screen or
swipe left on the carving progress screen.
5 mm
5.3.2 Set the Work Origin and Start Carving
Guides & Pictures / Snapmaker
How to Set the Work Origin
1. After receiving the G-code file, tap Yes and Next on the touchscreen to enter the Set Work Origin screen.
How It Works: Work Origin
Find out where the carving will be by setting the work origin. The work origin corresponds to the (0, 0)
coordinate origin in the software.
2. Tap X-/X+/Y-/Y+/Z-/Z+ to move the CNC bit to where the work origin will be (In this case, we set the center
of the image as the coordinate origin in the software). Now the CNC bit should be about 5 mm away from the
material.