Users Manual Part 2

CNC Carving

Quick Start Guide

You can also upload your own files by clicking

Open File

Editor

and configure the file settings.

Files sent by Wi-Fi can be found on the touchscreen: Files > Local.

You can also send the G-code files to the machine via the USB disk. Click Export G-code to file

in Snapmaker Luban and save it to the USB disk, then insert the USB disk into the controller

and select Files > USB on the touchscreen.

Make sure you have worn the CNC Safety Goggles. Insert the CNC bit into the ER11 collet (Flat End Mill is

required for our provided model). Make sure the end of the CNC bit is parallel with the edge of the ER11 collet.

Handle the CNC bits carefully and keep them out of reach of children.

Screw the entire unit onto the shank as tight as possible, then completely tighten the ER11 nut using the

open-end wrenches.

14mm Open-End Wrench 17mm Open-End Wrench

5.3.1 Prepare the G-code File

Guides & Pictures / Snapmaker

Install the Software and Complete the Initial Setup

Download our software Snapmaker Luban at https://snapmaker.com and install it. Then connect to a Wi-Fi

network: Enter the Workspace -> Connection -> Select Wi-Fi -> Click -> Select your machine -> Click

Open -> Tap Yes on the touchscreen.

Generate the G-code File and Send It to the Machine

① Open the test file from Case Library -> ② Click Process after configuring the settings in Configurations

section -> ③ Use the default settings specifically configured for the test file -> ④ Generate the G-code file ->

⑤ Load G-code to Workspace -> ⑥ Send G-code to the machine via Wi-Fi.

Congratulations!

Youarenowreadytoprint.Pleasecontinueto

generate the G-code file.