Users Manual Part 2

CNC Carving
78
|
Quick Start Guide
|
79
5.1.2 Initial Setup
Guides & Pictures / Snapmaker
5.2.1 Fix the Material
Guides & Pictures / Snapmaker
Plug the AC Power Cable into an electrical outlet. Switch the power on and follow the prompts on the
touchscreen: Read the Terms -> Name the Machine -> Connect to a Wi-Fi Network.
It is recommended to wait for 5 seconds when you turn your machine off and on again.
1. Place the provided material on the center of the CNC carving platform.
2. Attach the clamp set to the CNC carving platform, then fix the material by screwing the wing nuts.
The size of our provided model is 139.2 x 141.5mm. Make sure the clamp set does not
impede the movement of the CNC bit.
M4 x 70 Screw
Wing Nut
Fixture Accessory
Arched Fixture
Please skip this step if you
have completed the initial
setup.If youneedto change
the settings above, swipe
left on the home page of
the touchscreen -> select
Settings -> tap Wi-Fi or
About Machine as needed.
The initial guide, which
helps you get started, will
appear only once. If you
need to launch it again,
swipelefton the homepage
of the touchscreen-> select
Settings -> tap Guides .