Users Manual Part 2

Laser Engraving and Cutting
70
|
Quick Start Guide
|
71
8
7
You can also upload your own files by clicking Open File in Editor and configure the file settings.
2
4
3
1
6
5
You can also start engraving/cutting by using the USB disk, connecting with the USB cable, or
sending G-code files via Wi-Fi. For detailed instructions, please refer to our online user manual.
Unlikethe CameraCapturemethod,youwillneed to settheworkoriginif youusethemethodsabove.
3. ① Open the test file from Case Library -> ② Drag the image to where the cutting will be on the captured
platform -> ③ Click
Process
after configuring the settings in
Configurations
section -> ④ Use the default
settings specifically configured for the test file -> ⑤ Generate the G-code file -> ⑥ Load G-code to
Workspace -> ⑦ Set the thickness of the material -> ⑧ Click Run .
4. Remove the finished work and complete the assembly.
If you find the edges of the captured image are not aligned, you shall click Calibration to manually
calibrate the camera.
Zoom into the image and move the lines until they perfectly match the square, click Confirm ->
Apply to see the finished image.
Click Confirm and the finished image will be loaded into the quadrant in the coordinate system.
You can repeat the steps above if the edges of the captured image are still not aligned.
Share!
You can share your finished
work in our Facebook group
and our forum.