Manualshelf

Users Manual Part 2

ManualsBrandsShenzhen Snapmaker Technologies ManualsElectronics1600mW Laser Cutting Module
11121314151617181920
Laser Engraving and Cutting
68
|
Quick Start Guide
|
69
4.2.3 Fix the Material
Guides & Pictures / Snapmaker
4.3 Prepare the G-code File and StartCutting
Guides & Pictures / Snapmaker
Remove the engraved paper, then fix another provided material on the center of the laser engraving/cutting
platform.
1.
Download our software Snapmaker Luban at https://snapmaker.com and install it. Then connect to a Wi-Fi
network: Enter the Workspace -> Connection -> Select Wi-Fi -> Click -> Select your machine -> Click
Open-> Tap Yes on the touchscreen.
2.
Click Camera Capture in the laser G-code generator and then click Start. Wait for the machine to take
photos and stitch them into a panorama of the platform, click Confirm.
Make sure the clamp set will not collide with any portions of the machine.
You can also fix materials using other tools.
If you need to fix thick materials, refer to 5.2.1 Fix the Material.