Users Manual Part 2

Laser Engraving and Cutting
66
|
Quick Start Guide
|
67
4. Tap X-/X+/Y-/Y+ to move the laser dot to where the work origin will be, then tap Set Work Origin and Run
Boundary to check if the work origin is proper. If the work origin is improper, reset the work origin and run
boundary again.
4.2.2 Calibrate the Camera
Guides & Pictures / Snapmaker
If the laser module runs into any portions of the machine, turn off the machine immediately.
5. Tap Start, the machine will conduct an Auto Focus procedure.
1. Remove the engraved material. Place a piece of white and blank paper (no less than 150mm x 150mm) on
the center of the laser engraving/cutting platform, then fix it.
2. Tap Start, the machine will use the engraved square to calibrate the camera.
In the event of needing to remeasure the focal length and you are not sure how to proceed,
please refer to our online user manual for detailed instructions.
If you have detached the laser module from the X axis, or if you have reassembled the
machine, please recalibrate the camera: swipe left on the home page of the touchscreen ->
select Settings -> tap Laser -> tap Camera Calibration.