Manualshelf

Users Manual Part 2

ManualsBrandsShenzhen Snapmaker Technologies ManualsElectronics1600mW Laser Cutting Module
11121314151617181920
Laser Engraving and Cutting
64
|
Quick Start Guide
|
65
How It Works: Work Origin
Find out where the engraving/cutting will be by setting the work origin. The work origin corresponds to the (0, 0)
coordinate origin in the software.
How to Measure the Focal Length
1.
Place the provided material on the laser engraving/cutting platform, then fix it using the silicone plugs.
2.
Set the thickness of the material (1.5mm) and tap Save.
3.
TapX-/X+/Y-/Y+/Z-/Z+ to move thelaser module. After the laser shade has slightly touched the surface of
the material, tap Next. Make sure you have worn the Laser Safety Goggles before setting the work origin.