Users Manual Part 2

Laser Engraving and Cutting
62
|
Quick Start Guide
|
63
Please skip this step if you
have completed the initial
setup.Ifyouneedto change
the settings above, swipe
left on the home page of
the touchscreen -> select
Settings -> tap Wi-Fi or
About Machine as needed.
The initial guide, which
helps you get started, will
appearonlyonce.If youneed
to launch it again, swipe
left on the home page of
thetouchscreen->select
Settings -> tap Guides .
4.1.2 Initial Setup
Guides & Pictures / Snapmaker
4.2.1 Measure the Focal Length
Guides & Pictures / Snapmaker
Plug the AC Power Cable into an electrical outlet. Switch the power on and follow the
prompts on the touchscreen: Read the Terms -> Name the Machine -> Connect to a Wi-Fi
Network.
It is recommended to wait for 5 seconds when you turn your machine off and on again.
How It Works: Focal Point
The best focusing result can only be achieved when the Focal Point is right on the surface of the material
throughout engraving or cutting.
Perfect
TooClose
Too Far
How It Works: Focal Length
The machine engraves a few lines at different heights and identify the line of the best engraving result. The
distance between the laser module and the material surface, which is used for engraving this line, will be used
as focal length. You just need to set the thicknesses of different materials once the focal length has been
determined, the machine will automatically adjust to ensure that the focal length is consistent.