Users Manual Part 1

Before YouStart
1.7 Video Tutorials
We provide both the video tutorials and Quick Start Guide which help you get started. You can either read this
Quick Start Guide to finish assembly and begin your maker journey, or watch the video tutorials at https://
snapmaker.com
1.8 Used Symbols
CAUTION
NOTICE
TIPS
Ignoring this type of message might result in malfunction or damage of the
machine and injuries to users.
Details you should be aware of throughout the process.
Tips offer you convenient operations and additional options.
Make sure that the highlighted part is facing the right way.
Do not tighten the screws when this symbol appears. Always tighten the
screws when it is absent.
1.9 Get the Screwdriver Ready
The screwdriver head H 2.5 is used for assembling the machine. The other heads are used for maintenance.
Make sure the screw head holder has been put back inside of the handle before use.
10
|
Quick Start Guide
|
11
Screwdriver x 1
14mm Open-End Wrench x 1
Palette Knife x 1
Diagonal Pliers x 1
17mm Open-End Wrench x 1
USB Disk x 1
Silicone Plug x 8
Cable Tie x 1
Ball End Mill x1
Flat End Mill x 1
Tweezer x1
Hot End Kit x 1
Steel Strip Adjustor (For
Maintenance) x 1
Cable Holder x1
Divider x 6
Foot x 4 + M4 x 10 Hex Socket
ER11 Collet (Only for 3.175 mm
Head Screw x 4
CNC Bits) x 1 + ER11 Nut x 1
Wing Nut x 4
M4 x 70 Screw x4
M4 x 10 Hex Flat Head Screw
x 22
M4 x 8 Screw x68
M4 x 10 Hex Socket
Head Screw x 17
M4 x 30 Screw x12
Tool Box
Calibration Card x2
Wiping Cloth x 1
Laser Material x 2
CNC Material x1
Material Bag