User's Manual

iSmartTool Series User Manual

Note: If Auto is selected, the TPMS Relearn operation needs to be performed after

programming all required sensors.

Method 2 – Manual Create

This function allows users to manually enter sensor ID. Users can enter the

random ID or the original sensor ID, if it is available.

1. Select the wheel which needs to be programmed on the tool, place the

sensor close to the TPMS antenna of the tool, and tap Manual.

2. Use the on-screen virtual keypad to input a random or original (if available)

sensor ID and tap OK.

Note: Do not enter the same ID for each sensor.

3. Follow the on-screen prompts to write in the sensor ID to the sensor.

Notes:

•

If a random ID is entered, please perform the TPMS Relearn function after

programming is finished. If the original ID is entered, there is no need to perform

Relearn function.

•

If a vehicle does not support Learn function, please select the Manual option to

enter the original sensor ID manually, or trigger the original sensor at the

activation screen to get its information, before programming the sensor.

Method 3 – Copy by Activation

This function allows users to write in the retrieved original sensor data to the

specific sensor. It is used after the original sensor is triggered.

1. From the activation screen, select the specific wheel position and trigger the

original sensor. After the information is retrieved, it will be displayed on the

screen.

2. Place a sensor close to the TPMS antenna of the tool, and tap Replication.

3. Tap Program to write in the copied sensor data to the sensor.

Note: Once programmed with Replication, the specific sensor can be installed in

the wheel directly to be mounted on the vehicle and the TPMS warning light will turn

off.

Method 4 – Copy by OBD

This function allows users to write in the retrieved sensor information to the

specific sensor after performing Reading ECU ID.

If the user had performed both the Read ECU ID function and the trigger