User's Manual
3 8
guarantee that interference will not occur in a parcular installaon.
If this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modificaons to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
FCC WARNING
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in
a residenal installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment of
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
*Reorient or relocate the receiving antenna.
*Increase the separaon between the equipment and the receiver.
*Connect the equipment into an outlet different from that to which the
receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
4. Press OK key to confirm;
8.2 ALARM SET TING
You can use the alarm to remind yourself to feed baby /change diapers /
sleep, etc.
1. Press the Menu/Eixt key and the menu will pop up;
2. Press the LEFT key or RIGHT key unl the alarm icon is
highlighted then press OK key to enter into sub-menu;
3. Press Le key or press Right key to select desired alarm;
4. Press OK key to confirm;
Note : If the alarm is ringing and no one to answer, then the ringing will last
1 minute and then stop , aer 3 minutes the ringing will start again.
The ringing will sound up three mes total if no one answer.
8.3 LULLABY SETTING
You can soothe the baby to sleep by playing a gentle lullaby from the baby unit.
1. Press the Menu/Eixt key and the menu will pop up;
2. Press the LEFT key or RIGHT key unl the lullaby icon is
highlighted then press the OK key to enter into sub-menu;
3. Press Le key or Right key to select desired lullaby;
4. Press OK key to confirm;
8.4 PAIRING THE CAMERA AND MONITOR
1. Press the Menu/Eixt key then the menu will pop up;
2. Press the LEFT key or RIGHT key unl the camera icon
is highlighted then press OK key to enter into sub-menu;
3.Press Le key or Right key to select the desired camera to pair;
4. Press OK key to start the pairing ;
5. While the LED is flashing then press the PAIR buon on the back of camera;
6. Once paired, then the screen will display the image from the camera.
7. If unsuccessful, please repeat above steps.