Users Manual

Trouble Shooting
1. My dog does not respond when I press a button.
• Make sure the Receiver has been turned on.
• If your range has reduced from the first time you used the Remote Training Collar, the
battery(s) may be low in either the Remote Transmitter or Receiver.
• Many factors can impact the amount of range you have with the Remote Trainer. For a list of
these factors, see "How the System Works".
• Test the Receiver. See "How to test the functions" for details.
• Increase the Stimulation Level. Refer to "How to Find the Best Warning
Tone/Vibration/Static Shock Level for Your dog" for more information.
• Make sure the Receiver's Contact Points are placed snugly against your dog's skin. Refer to
"How to Fit the Receiver" for more information.
2. The Receiver will not turn on.
•Make sure the Receiver has been charged. For the initial charge, be sure to charge it for4 hours.
Subsequent charges only take 2~3 hours.
3. The Receiver is not responding to the Remote Transmitter.
• Verify the Receiver is on.
• If the indicator is blinking rapidly, fully charge the Receiver.
• If the first 2 solution did not resolve your problems, please check “How to pair the Remote
Transmitter & Receiver” section.
FCC Statement
USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions,may cause harmful interference to radio communications.