Users Manual

Tips:
The Receiver is paired up to Remote Transmitter in Channel 1 by factory default setting,
If you buy a new Receiver, you follow above pairing instruction to pair up to channel 2. The
system can pair up to 2 Receiver in 2 different channels.
If you can not pair the device successfully, it maybe caused by the signal interference. Please try
in a new place or contact with our service center.
VI. Training Tip（最适合的等级、距离）
How find the best stimulation for your dog?
Important: Always start at the lowest level and work your way up.
The Remote Training Collar has 8 types Warning Tone, 16 levels for Vibration and 18 levels for
Static Shock. For Warning Tone, there are 8 types of tones and there is only frequency difference
among different types. For Vibration and Static Shock, level 1 is the lowest; level 16 is the highest
for Vibration and 99 for Static shock. This allows you to choose the Stimulation level that is best
for your dog. Once you have placed the Receiver on your dog, it is time to find the Stimulation
Level that is best for him. This is called the Recognition Level. A slight change in your dog's
behavior, such as looking around in curiosity, scratching at his collar, or flicking his ears, indicates
the Recognition Level that is best for your dog.
Follow the steps below to find your dog's Recognition Level:
1. Starting at Level 1, press the Warning Tone/Vibration/Shock Button continuously for 1 to 2
seconds. Note: When the Warning Tone/Vibration/Shock Button is held down for 10 consecutive
seconds, the Remote Transmitter will "time-out", and you must release and press the button
again before additional stimulation can be delivered.
2. If your dog shows no reaction, repeat the Stimulation Level several times before moving up to
the next level.
3. YOUR DOG SHOULD NOT VOCALIZE OR PANIC WHEN RECEIVING STIMULATION. IF THIS
HAPPENS, THE STIMULATION LEVEL IS TOO HIGH AND YOU NEED TO GO BACK TO THE PREVIOUS
LEVEL AND REPEAT THE PROCESS.
4. Move up through the Stimulation Levels until your dog reliably responds to the stimulation.
5. If your dog continues to show no response at highest level of Vibration or Static Shock, check
the fit of the Receiver. If your dog has long or thick hair, contact our Customer Care Center to
obtain a longer set of Contact Points. Then go back to #1 and repeat the process. If this still does
not yield any results, your dog's hair will need to be trimmed around the Contact Points.
If, after completing all of these steps, your dog still does not indicate he is feeling the stimulation,
please contact our customer service.