User's Manual

3. Install device (GD810C and GD810S)

Note: Please turn off the door opener’s power before the following operation.

1) Find out a right place to fix the controller. We provide a mounting bracket which can fix the

controller on the wall, we also provide two bind belts for you which can fix the controller to the opener’s

bracket;

2) Find out the right terminal which will connect to our controller;

3) Insert one end of the cable to our controller’s door 1 connector(see the overview figure); and insert

the other end of the cable to the door opener’s terminal;

4) Close your door, install the sensor(GD810S) on the top flap of your garage door;

If the surface of your door is clean and smooth, you can use the double-sided adhesive taps to fix the

mounting bracket of the sensor to your door, then put the sensor(GD810S) into the mounting bracket.You

can also use the self-tapping screws.

4. Testing

Power on the device and door opener, open or close the door,check the state on your app.

If the state is not correct after you open/close the door for 3 times, please check the position of the

toggle switch. If you connect the cable to door 1 connector, you have to flip the toggle switch of the sensor

to 1. If you connect the cable to door 2 or 3 connector, you have to flip the toggle switch of the sensor to 2

or 3 accordingly.

How to reset sensor(1 or 2 or 3)?

Press and hold the sensor button(1 or 2 or 3) for 3 seconds or above until the sensor light flashes in

yellow.