Alarm Clock Night Light Wireless Charger Model: SYW0258 I.
II. Functions A.Power Connection 1.Plug the USB-A end of cable into the power adapter while plug Type-C end into the product. 2.The product will be ready and stand by after all indicators are on. B.Wireless Charging 1.Output: 15W 2.Indicator Display:Power connection successful – blue light flashes once Standby – light off Charging – blue light on Charged – light off FOD – blue light flashes continuously C.Alarm Clock Functions 1.Four Buttons: Alarm, +, -, Light. 2.
4) Click Alarm button a third time to finish alarm time setting; 5) Alarm bell rings 3 minutes before automatic switch-off while no any operation. 6) Touch any button to enter Sleepy Mode when bell rings. Bell will rings for 3 more times after 5 minutes. The indicator flashes and Alarm button is out of function during the Sleepy Mode. If time setting is needed, please long press “+” to stop alarm 1 or long press “-” to stop alarm 2.
2.Do not squeeze or collide. 3.Do not disassemble or put into the fire, water, to avoid short-circuit leakage. 4.Do not use wireless chargers in severe high temperature, humidity or corrosive environments to avoid leakage of damaged circuits. 5.Do not place too close to magnetic cards (ID cards, bank cards, etc.) with magnetic strips or chips to avoid magnetic card failure. 6.Keep more than 20cm between the implanted medical device (pacemaker, implantable cochlea, etc.
Manufacturer Shenzhen Shuoyu Technology Co., Ltd. Address: 30F East Block, Wenhua Bldg, 1027 Shennan East Road, Luohu District, Shenzhen, Guangdong, China Importer Caliber Europe BV Address: Kortakker 10 4264 AE Veen, The Netherlands UP Global Sourcing UK (Ltd) Manor Mill,Victoria Street, Chadderton, Oldham, OL9 0DD，UK FCC compliance statement This device complies with Part 15 of the FCC Rules.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
