User's Manual

12 13
PlACing A CAll on hold
•
Hold the volume button on your Bluetooth® Headset for 3 seconds until you hear a beep.
To resume your conversation hold the volume button again until your hear a beep. Your mobile phone must
support this feature.
CAll WAiting
•Yourheadsetwillindicatethatthereisanincomingcallbybeeping.Torejecttheincomingcall,press
and hold main button for 3 seconds. To answer the incoming call and keep the current call on hold,
tap the main button. To answer the incoming call and hang up the current conversation, double tap
the main button.
•Ifyouareontwocalls,youcanswitchbackandforthbetweencalls.Toswitchbackandforthwithout
hanging up, tap the main button. To switch back and forth with hanging up on the current call, double
tap the main button.
trAnsFerring A CAll
•
Headset to phone: Tap the main button twice when you are on the phone call. Then, the
phone call will transfer from your Bluetooth® headset to your mobile phone.
•
Phone to Headset: Tap the main button twice to transfer back to your Bluetooth® headset.
reJeCting A CAll
•
Press and hold down the main button of your Bluetooth® headset until a short tone is heard in
approximately 4 seconds and then release the main button. Depending on your mobile phone settings,
the call will either go to voice mail or the person calling will hear a busy signal.
ending A CAll
•
Tap the main button to your headset to end an active call.
right or leFt eAr Fitting
•
The Just Wireless® Bluetooth® Headset is ready to wear on your right ear.
If you prefer to use it on your left ear, rotate the ear hook to the other side of the headset.