User's Manual

4 5
ChArging your heAdset
Your Just Wireless® Bluetooth® Headset comes with a built in rechargeable battery, and must be
fully charged before using. Use the supplied USB Cable to charge your headset by plugging it into the
charging jack shown below.
•
The red LED light will flash
when you have a low battery
level. It is suggested to
charge the headset at this time.
•
The red light will illuminate solid red during charging and will turn solid blue
when fully charged. It will take approximately 1-2 hours to charge.
•
Your headset cannot be used while charging.
turning the heAdset on And oFF
ON Mode: Press and hold down the Main Button for 3 seconds. Your headset will beep and the blue
LED light will flash 4 times. Now your headset is on.
OFF Mode: Press and hold down the Main Button for 4 seconds. You headset will beep and the red
LED light will flash 2 times. Now your headset is off.
Standby Mode: To save battery power, your headset will automatically change to standby mode
when not in use. The blue LED light will flash every 7 seconds. The headset will automatically change
back to ON mode, when a call is incoming, or when the Main Button is pressed.
GETTING STARTED