Product Chart

Audio Output Jack
This jack is a standard 6.35mm stereo audio output
jack. Use a 6.35mm stereo plug cable to connect
audio equipment while you play.
MIDI DIN Output
This jack is a standard MIDI 5-pin output jack, you can
use this jack to connect other MIDI devices with a
MIDI 5-pin cable to perform.
USB MIDI/Charging Jack
You can charge the instrument through this jack,also
as a firmware upgrade and USB-MIDI output.
Power Switch
This button is the power switch of the instrument.
Press it up and down to switch it.
Built-in Speaker
The instrument has built-in speakers, allowing you to
play solo without an external amplifier.
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications to this device
not explicitly approved by manufacturer could void
your authority to operate this equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
RF Exposure Information
The device has been evaluated to meet general RF
exposure requirement. The device can be used in
portable exposure condition without restriction.