User's Manual

用户手册
TWS 蓝牙耳机
型号：TS10
产品参数
型号：TS10
蓝牙版本：V5.0
传输频率：2.402G-2.480G
连接距离：≧10M
支持协议：HSP、HFP、A2DP、AVRCP
音乐播放时间：6-7H
待机时间：约 180H
耳机电池容量：3.7V 50mAh
充电仓电池容量：3.7V 800mAh
充电输入：5V 500mA
充电时间：2-3H
工作环境：-10℃-50℃
开机配对
1.从充电仓同时拿出左、右耳机，耳机自动
开机（或同时按住多功能键 3S 左右开机），
开机时耳机亮蓝灯。
2.开机后左、右耳机自动进入双耳配对模式，
配对成功后主耳红、蓝灯交替闪烁，副耳灯
灭。
3.打开手机蓝牙功能，搜索蓝牙设备配对名
为 ： TS10, 点 击 连 接 （ 如 需 密 码 ： 请 输 入
“0000”），连接成功后指示灯灭。
关机
1.使用过程中，同时将左右耳机放回充电仓
内自动关机，或长按任意耳机多功能键直至
红灯亮起后松开关机。
2.耳机远离连接设备或开机后 5 分钟后未配
对成功，耳机将自动关机。
再次使用
1.将单耳机或双耳从充电盒中取出，耳机自
动与上一次连接手机自动回连。
2.如耳机在关机状态或不在充仓内，将耳机
放入充电仓内激活后再取出，或长按耳机多
功能键开机，耳机将与手机自动回连。
充电
1.为耳机充电：耳机放入充电仓，并合上上
盖开始充电。耳机充电时，显示屏电量柱并
依次闪烁，每格电量为 25%，耳机充满电，显
示屏电量柱并 4 格常亮，4 格电量为 100%。
2. 充电仓充电时，显示屏显并显示实时电
量，充电仓充满电后，显示屏显并显示为 100%
3.为充电仓充电：插入 type C 插头对充电仓
进行充电，充电过程中，显示屏显并显示实
时电量，充电仓充满电后，显示屏显并显示
为 100%。
按键功能操作
单击 L/R 耳:接听/挂断电话，播放/暂停音乐
双击 L 耳：切换上一曲
双击 R 耳：切换下一曲
三击 L 耳：音量-
三击 R 耳：音量+
长按 L/R 耳 2S：唤醒 Siri 功能（只支持 IOS
系统及部分安卓系统）
长按 L/R 耳 3S：开机
长按 L/R 耳 5S：关机
提示
1.使用本产品前请仔细阅读使用说明书。
2.首次使用本产品请充满电后使用。
3.如果产品长时间（超过 15 天）不使用请进
行充电。
4.必须选择正规厂家生产且有 CCC 认证的充
电器进行充电。
User manual
TWS Bluetooth Earbuds
Model: TS10
Product parameters
Model: TS10
Bluetooth version: V5.0
Transmission frequency: 2.402G-2.480G
Connection distance: ≧10M
Supporting protocols: HSP, HFP, A2DP, AVRCP
Music playing time: 6-7H
Standby time: about 180H
Headphone battery capacity: 3.7V 50mAh
Charging battery capacity: 3.7V 800mAh
Charging input: 5V 500mA
Charging time: 2-3H
Working environment: -10 ° C -50 ° C
Power on & Pairing
1. Take out the left and right earbuds from the
charging case at the same time, the earbuds will
automatically turn on (or press the multi-function
key for 3S at the same time). The earbuds will light
blue after turn on.
2. After turn on, the left and right earbuds
automatically enter into pairing mode. After
paired successful, the main earbud red and blue
lights flash alternately, and the auxiliary earbud
light turn off.
3. Turn on the Bluetooth on mobile phone, search
for the Bluetooth device pairing name: TS10, click
the name to connect (if need password: please
enter "0000"), the indicator will be off after
connected successfully.
Power off
1. During using, put the left and right earbuds back
into the charging case to shut down, or press any
earbuds multi-function keys until the red light on ,
then release and the earbuds shut down.
2. The earbuds will be power off automatically if
the earbuds far from the device or not pairing with
any device for 5 minutes.
Use again
1. Take out the single earbud or both earbuds from
the charging case, and the earbud will
automatically connect back to the last connected
device.
2. If the earbudt is in the off state or not in the
charging compartment, put the earbud into the
charging caset to activate it and then remove it, or
press and hold the headset multifunction key to
turn it on, the earbud will automatically connect
back with the mobile phone.
Charging
1. Charge the earbuds: Put the headset into the
charging case ad close the case to start charging.
The screen LED flashes in sequence. 25% power
per grid, four grids light on when earbuds in full
charging.
2. When charge the charging case: the screen
displays the real power. When fully charged, the
screen displays 100%.
3. Charging the charging case: Insert the type C
cable to charge the case.During charge, the
screen displays the real power. When fully
charged, the screen displays 100%
Button function operation
Click the L/R ear: answer/hang up the phone,
play/pause
Double click L: last song
Double click R:next song
Three click L : volume -
Three click R : volume +
Long press L/R for 2S: wake up Siri function (only
support IOS system and parts Android system)
Long press L/R for 3S: power on
Long press L/R for 5S: power off
prompt
1. Please read the instruction manual carefully
before using this product.
2. Please fully charged this product for first time
using.
3. If the product have not used for a long time
(more than 15 days), please charge it.
4. Must select a charger that is produced by a
regular manufacturer which has CCC certificate.