User's Manual

Operating GuideOperating Guide
Step 4
How to Test
the Functions
Test the static shock function
• Put the test-light on the contact point of the
Collar Receiver. Turn on the Remote
Transmitter, press the Up/Down to adjust
the intensity level.
• Press shock button and the bulb will
flash, signifying that the Shock function works.
• Please make sure the Shock level is above 4 when testing the function to
see more clearly.
Note: If wanting to test the shock function on yourself, please ensure your
finger or hand is across both contact points to ensure the connection is
complete. Otherwise, user will feel no stimulation.
Test the vibration function
• Turn on the Remote Transmitter, press the Vibration button first then
press the Up/Down button to adjust the vibration level.
• Press the Vibration button on the Remote Transmitter, the Collar Receiver
will vibration, signifying the Vibration function works.
Test the beep function
• Turn on the Remote Transmitter.
• Press the Tone button, the Collar Receiver will beep, signifying the
Tone function works.
Note:
1. To save power, the transmitter will go into Standby mode if there’s no
operation in 5 minutes. You can press any button on transmitter to
activate it and its screen will display.
2. The Collar Receiver will go into Sleep Mode if there is no operation for
2 minutes and The LED stop flashing. Will be activated when receiving
the command (shock, vibration or tone) from the transmitter.
Step 3
How to Syncing the Remote
Transmitter & Collar Receiver
1. Press any button on the transmitter to activate it.
2. Select Channel A , B or Public Channel
A+B .
3. Power Off the Collar Receiver by press the Power
button on Collar. (a beep power On, 2 beeps
power Off.)
4. Press Power button afresh and HOLD it for
3 seconds, the LED will start to flash green quickly
for 10 seconds.
5. Now you can hear the first beep from the Collar
Receiver, and then press any of the command
button (tone, shock or vibration) of the Remote
Transmitter before the green light on the receiver
stop flashing quickly.
6. You will hear the second beep from the Collar
Receiver, which signifies that the transmitter and
the receiver have been synced.
7. To sync the Remote Transmitter and the second
Collar Receiver, repeat step 2 through 6.
8. Please be sure to choose the other channel.
Note: According to the factory default settings, when
the Collar Receiver has been turned on the syncing
should be completed within 10 seconds, thereby you
have to press the COMMAND BUTTON in good time
or press it at least within 10 seconds. Please DO
NOT try to sync the transmit er with the two Collar
Receivers (if any) at the same time.
Channel A
Channel B
Public Channel A+B
(Remote 2 Receiver
at the same time)
Press and hold
for 3 sceonds
13 14