User's Manual

Operating GuideOperating Guide
Charge the Collar Receiver
1. Lift the rubber cover on the Collar Receiver charging jack.
2. Connect the USB cable connectors to the charging jack on Collar
Receiver.
3. Connect the USB cable port to the power adapter, power band or your PC.
4. The red LED light on the Collar Receiver will flash RED.
5. Charge the Collar Receiver for at least 3 hours for the first charge or
until indication that charging is complete.
6. After the Collar Receiver has been fully charged, the LED light will turn
solid GREEN.
7. When charging is finished, put the rubber cover in place to keep
the internal unit from dust and water.
8. Please charging the Collar Receiver immediately when the LED light
flash RED.
Note: Turn the Receiver Collar off when it is not in use. Approximate battery
life is 1 week after fully charged, depending on frequency of use.
Warning:
Please use those with 5V
output voltage. The output
voltage information is
usually described on the
surface of power adapter.
Power adapter with output
voltage over 5V may
cause damage to the
training collar.
Remote Transmitter:
1. Press any button to turn ON the Remote Transmitter.
2. Press the Channel/Lock button to select Channel A ,
Channel B or Public Channel A+B .
2. Press Up/Down buttons to adjust the intensity level of vibration or static
shock.
3. A/B channels indicates either channel A, channel B or channel A+B on
the transmitter. Select one channel for use with one Collar Receiver. If
encoded at the public channel A+B, you can control the Collar Receiver
at any of channels.
4. The LCD screen will go to sleep if no use in 30 seconds, to conserve
battery power. You can simply press any button to activate the
transmitter.
5. Press and hold the Channel/Lock button to lock or unlock the
intensity level of vibration or shock
Step 2
How to use the
Dog Training Collar
Collar Receiver:
1. To turn On the Collar Receiver, press the Power button, a beep
sound will heard, the LED light will flash green every 7 seconds.
2. To turn Off the Collar Receiver, press the Power button, 2 beeps
sound will heard. The indicating light will turn off.
11 12