User's Manual

10. Online Engraving

For engraving over USB, you connect the computer and the engraving machine using the data cable. While engraving, the

computer cannot be powered off, and the computer cannot enter the screen saver or hibernate, to prevent data transfer failure.

When you use the USB cable to connect the engraver to the computer, and if the driver cannot be loaded correctly, proceed as

follows:

Open the distributed SD card and select the path (computer \F:\2. software and driver \online driver\USB driver) to install the file.

• Turn on the engraving machine, connect the USB cable, open the laser engraving and slicing software, click monitor, display the

engraving machine model and other information, indicating that the computer has been successfully linked.

• Once the engraving file is sliced, it is ready for online engraving.