User's Manual

Loosen the hand screws shown in the
figure and pull down the acrylic cover to
the lowest point after tightening the
screw.
10
8
After loosening the hand screws
shown in the figure and allowing the
bottom surface of the acrylic cover to
come in contact with the item being
engraved, tighten the screw.
Loosen the hand screws shown in the
figure, and lift the acrylic cover up to the
highest position and then tighten the
screw.
Schematic
Schematic
Schematic
Engraving object
6. Focal Length Adjustment
A2