Specifications

SMG-002A Specification
1) IC chip: Learning code 1527
2) Working current: 8~10mA
3) Frequency: 433.92mhz
4) Working power: ≤10MW
5) Working distance: 10-100meters(spacious)
6) Static current: 0
7) Battery voltage: 3.0V
8) Modulation: ASK
9) ±200KHz
10)Temperature Range: - 40 ℃ to + 85 ℃
Open you motor to get the receiver and find the programming button.
1.Press and release the programming button
2.Pressing and hold our button of our remote control about 30second.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
receiver is connected.
adio/TV technician for help.
Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.