Data Sheet
Table Of Contents
- 2.Module interface
- Pin definition
- Description: P identifies the power supply pin, I/O represents the input and output pins, and AI represents the analog input pin.
- 3. Electrical parameters
- 4 RF characteristics
- 5 antenna information
- When using a PCB on-board antenna on a Wi‐Fi module, to ensure optimal Wi‐Fi performance, it is recommended that the antenna portion of the module be at least 15 mm away from other metal parts.
T102 DATASHEET
深圳市盛创威科技有限公司
9
Version 1.0
6.2 PCB Recommended Package
Figure 5 T102 PCB
package drawing
5.3 Production Guide
The factory module storage conditions are as follows:
1. The moisture-proof bag must be stored in an environment with a temperature <30 ° C and a humidity
<85% RH.
2. For dry-packed products, the shelf life should be 6 months from the date of sealing of the package.
Precautions
1. In the whole process of production, the operator of each station must wear an electrostatic ring.
2.
When operating, prevent the module from getting wet or dirty.
The host will Satisfy Class I or Class Ⅱ permissive change based this module FCC ID.
If the FCC identification number is not visible when the module is installed inside the host, then
the outside of the device into which the module is installed must also display a label referring to
the enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module Contains FCC ID:2ASKS-T102 or “Contains FCC ID:2ASKS-T102 .Any similar
wording that expresses the same meaning may be used.