User's Manual

Getting Started 8
Charging the battery
Your phone is powered by a rechargeable battery.
A new battery is partially charged and a sound alert
will be emitted when the battery level reaches low
(if the battery alert is set to On).
Once the battery and battery cover are back in
place, you can charge the phone. Plug in the
connector as shown below. Then plug the other end
into a power socket.
The battery symbol indicates the state of charge.
During charging, the charge indicators will scroll; it
takes about 2.5 hours to fully recharge the battery.
When all the scroll bars are steady, the battery is
fully charged. You can then disconnect the charger.
Depending on the network and condition of use,
talk time goes up to 10 hours and stand-by time up
to 1 month.
Keeping the charger plugged to the mobile phone
when the battery is fully charged will not damage
the battery.
The only way to turn off the charger is to unplug it,
so use an easily accessible power socket.
Inserting the Micro-SD Card
The maximum capacity of Micro-SD that X800
can support is up to 8GB.
Remove the back cover
The micro-SD card slot is visible only when the
back cover of the phone is removed.
X800_GB_EN.book Page 8 Thursday, May 29, 2008 6:10 PM