User's Manual

8 Getting Started
During charging, the battery symbol scrolls. It takes
about 6 hours to fully recharge the battery.
Depending on the network and condition of use,
talk time goes up to 8.5 hours and stand-by time up
to 640 hours in the dual mode and 1,000 hours in
the single mode.
Keeping the charger plugged to the mobile
phone when the battery is fully charged will not
damage the battery. The only way to turn off
the charger is to unplug it, so it is advisable to
use an easily accessible power socket.
If you do not intend to use your phone for
several days, we recommend that you remove
the battery.
You can use the phone while it is charging. If
the battery is completely flat, the battery
symbol will only reappear after a few minutes
of charging.
Set your SIM card slots
The first time you turn on your phone, you may
need to set the two SIM card slots.
To identify the two SIM cards, you can set different
names, ringtones, message alerts, and icons for
them.
1. Check the Slot 1 and Slot 2 for the SIM cards
(see Step 3 in "Insert SIM cards").
2. Check that your phone is switched on.
Long press ) if necessary. Enter the PIN
code if required. A PIN code is a 4- to 8-digit
secret code of your SIM card. It is
preconfigured and communicated to you by
your network operator or retailer.
If you enter an incorrect PIN code three times
in succession, your SIM card will be blocked. To
unblock it, you must request the PUK code from
your operator.
3. Press
,Yes when asked whether to start setup:
On the slot setup screen,
+ or - : Move to a setup item of the same slot.
L: Enter the edit screen or option list.
RBack: Return to the previous menu.
To switch between two setup screens:
On Slot 1 setup screen, press
,Next;
On Slot 2 setup screen, press RBack.
4. To select the primary SIM,
press
,Next at the end of Slot 2 setup screen;
press < or > to select;
press
,OK to confirm.
X710_En_Book.book Page 8 Thursday, October 23, 2008 10:12 AM