User's Manual

10 Getting Started

*Depending on the network conditions, user

settings, method of use, etc the actual results may

differ.

Keeping the charger plugged to the mobile phone

when the battery is fully charged will not damage

the battery. The only way to turn off the charger is

to unplug it, so it is advisable to use an easily

accessible power socket.

If you do not intend to use your phone for several

days, we recommend that you remove the battery.

You can use the phone while it is charging. If the

battery is completely flat, the battery icon will only

reappear after a few minutes of charging.

Insert a micro SD card

1. Lift up the micro SD card cover on the left-hand

side of your phone as shown below. If held

properly, the card’s gold contacts will be facing

upwards.

2. Gently slip the card into the micro SD card slot

and press it down until the card locks into place.

To remove the micro SD card, push down the card

into its slot and release it. The card will spring out

of the slot.

The maximum capacity of micro-SD that X500

can support is up to 2GB.

Setting hotkeys

You can configure the numeric keys

and

to access your favorite features.

Once they have been set, you can simply long press

the numeric key to access the corresponding

features.

Majority of the hotkeys have been preset and

configured. To check the hotkey settings, go to Settings

> General > Shortcuts > keypad. To change the hotkey

setting, press the numeric key you wish to change and