User's Manual Part 2

To comply with RF exposure requirements, a minimum separation distance of 80cm

80 cm

◆ The transceiver operates in 12 V negative ground systems only! Check the battery polarity and

voltage of the vehicle before installing the transceiver.

◆ Use only the supplied DC power cable or a optional DC power cable.

◆ Do not cut and/or remove the fuse holder on the DC power cable.

For passenger safety, install the transceiver securely using the supplied mounting bracket and

screw set so the transceiver will not break loose in the event of a collision.

Antenna substitution:

Donot substituteany antenna fortheone supplied

orrecommended bythemanufacturer orradiodealer.

Youmaybeexposing personorpersons toexcess radio frequency radiation.

Youmay contact your radio dealerorthemanufacturer forfurther instructions.

aintain a separation distance from the antenna to person(s) of

at least

, 50% duty Cycle.

ìThis transmitter is authorized to operate with a maximum duty factor of 50%, in

typical push-to-talk mode, for satisfying FCC RF exposure compliance requirements.î

is required between antenna and person to meet the limits for occupational/controlled exposure.

SAMHOOSAMHOO