User's Manual

 Owner’sManual
9


BasicOperations
Installation&ModuleInspection
Open the package, check whether allmodules arefirmly installedinthebase
station.SeeFig.2forcompletionofinstallation.
Toinstallthemodulescorrectly,youmust:
*Poweroffthebasestationbeforeinstallation.
*Findthelocationofmodules,tak ecaretotheirgroovedirectionandthepins
insidetheba
sestation,andinsertthemoduleintothebasestationinaparallel
manner.
*Tightenthescrew sonbothsidesofthemodule.
Note:Thereisnoscrewonbothsidesoftheduplexermodule,besurenottolet
thebackofbasestationfacedown,themodulema
yslipoffandcausedamage
topeopleortheequipment.

ConnectingtheFeederandAntenna
Afterthecompletionofmoduleinstallation,youshouldconnecttheTX&RXport
of the base station and the High&Low ends of the duplexer together with
feedersproperly.
WhentheTXfrequencyofthebasestationishigherthanitsRXfrequency,the
connectingdiagramisasfollows: