Quick Start Guide

ManualsBrandsShenZhen S-HANDE Technology ManualsElectronicsWireless remote sex toy

Hold on 3s.

USB MAGNETIC CHARGING

100%

POWER BANK

10000mAh

Connect the device to USB port to charge.

Do not use the device while charging.

Please connect with power adapter below 5V.

Can not keep in water for a long time.

*WARNING: Please DO NOT use adaptor with ">5V" output

ON / OFF

SWITCH MODES

1.Vibrator 2.Remote :

1.Vibrator

2.Remote :

9 PATTERNS

DISTANCE

2.Remote :

Change the

cell battery

Open: Holde the remote.

Press and slid down

the cap.

Open/Close The Cap

Close: Set the cap in right

position.Press and

slid it into the slot.

① ②

Please remove the plastic

insulator before using it for

the first time

Insulator

1.38 in ( 35 mm )

2.76 in ( 70 mm )

3.54 in ( 90 mm )

1.93 in ( 49 mm )

*Please make sure your toy is fully charged while the first time

The longest working distance:

<10m

SIZE

QUICK START GUIDE

PRODUCT CLEANING

SAFETY

Do not use it at temperature over 167℉/75 ℃.

Stop using it when any discomfort occurs.

It is recommended to use it with water-based lubricant.

Do not use it if you find the product unsmooth or damaged.

Keep out of reach of children.

WARNING

MADE IN CHINA

III

1. This appliance can be used by children aged from 18

ears and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or

instruction concerning use of the appliance in a safe way

and understand the hazards involved.

2. Children shall not play with the appliance.

3. Cleaning and user maintenance shall not be made by

children without supervision.

4. The pr

oduct must only be supplied at SELV.

Battery

FCC ID:

： 3V 230mAh

2AT5OSHD-S257

Model Number: SHD-S257

SHENZHEN S-HANDE TECHNOLOGY CO., LTD

WEB: WWW.SEXHANDE.COM

Address:2/F, Building 8, Xinxintian Industrial Park,

Xinsha Road, Shajing Street, Baoan District, Shenzhen, China

Made in China

FCC Compliance Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

‐Reorient or relocate the receiving antenna.

‐Increase the separation between the equipment and receiver.

‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

‐Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.