User Manual

Ver 3.0
2. Please check if the batteries have low power or check if the power adapter is well connected. Besides,
the condition of the disc (scratches, dirty, debris, cracks, etc.) will cause equipment malfunction or shorten
the life of the laser head. So please check your CD condition, and try a new CD to have a test.
Specifications and parameters:
Support disc type: CD, CD-R, CD-RW
Support music format: CD-DA, MP3, WMA
Power source: DC 5V/1A
Battery: Lithium-ion polymer, 3.7V
-charge time:3h, When fully charged, the indicator light will change from red to blue
Frequency response:20-20k Hz
D/C conversion: 16Bit
SNR (signal to noise ratio): > 80DB
Distortion: < 1%
Overall dimensions: 152*135*24mm
Warm Tips
1. Prevent excessive volume from damaging your hearing when adjusting the volume.
2. Avoid the CD player contacts with moisture, rain, sand or various heat sources
3. Do not disassemble, repair by yourself.
4. When riding a bicycle, driving a car please don't use the CD player with headphones to avoid
danger.
Warning:Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Statement:This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.