User's Manual
P4/P9
2） shieldingsecondjumperplugonCH‐R2channelreceiver,isreceivingthechannelsignaldoesnotcause
alarm,signalintensityisnotthroughthelights.
3） receivethirdsignalsonCH‐R1channeljumperplugshieldisnotcausedbythereceivedsignalchannel
alarm,signalintensityisnotthroughthelights.
4） fourthjumperplugwillmakethesystemintheprobemode,butadditionalprobe.
5） J9plug in thesignal isused in powersupply of EG105signal source, ifyou do notplug in theuse of
DSP'sownsignalsource.
Thefirstthree
functionscanbesetaccordingtotheactualuseoftheneed,inadditiontothedebugging
can also be used to setthe signal to a certain way to allow the signal to signal intensity of a channel.
Aftersettinguptoacertainway,weneedtoplayanewroleinpower.
4.
Sensitivitysetting
J3, J2is usedto set thesensitivity. SLT1,SLT2, SLT3, SLT3, SLT4 ofthe four jumperis not insertedto the
highest sensitivity, decreased from the bottom to the top plug jumper jumper sensitivity, a position can
onlybeinsertedornotinserted.Setupafterthepower
istoreplayarole.
Fiveinstallationandcommissioning
1.Mountingantenna
In accordance with therequirementsofinstalled antennabracket, severalsocket positionto plug onthe
CH‐TR, ANT,CH‐R1 and CH‐R2 transmitting board,M6000G‐R board, M6000G‐TR board magnetic system
can be installed in M6090G‐TR,M6088G‐TR,M6088SG‐TR,M6088G‐TR and M6090G‐R,M6088G‐R,
M6088SG‐R,M6088G‐Rantennaframe.
2.environmentaltesting
Installation, wiring can be properly after the observation of the corresponding receiving channel in the
absenceofthelabeloftheenvironmentalinterferencesignal,ifthesignalisverystrong,youneedtocheck
the reasons, it will be eliminated or weakened. If you can find no way to eliminate the source of
interferenceorweaken,itcanonlyreducethesensitivity ofthedevice.Anormalenvironmentisnormal,
thetwogridisstrong,itisanotverygoodenvironment.
Synchronousonline
interfaceSY
Synchronoussignal
sourceselectionJ9
Sensitivity
adjustment
Receivingchannel
screen