User's Manual

goods off the protection block or pull the pin out of the
jack of the 15921N in 10 seconds, this will avoid the
15921N’s alarm. The 15921N will then detect the states of
the switch and the jack to decide to go into ward mode or
idle mode.
Disarm alarm:
When the 15921N alarms, press the reset bottom of the remote
controller, the 15921N will stop alarming and send signal
to disarm the 15901R.
Attentions: disarm the alarm of 15921N as soon as possible; when the alarm
is undertone, replace the cell in it.
For reuse:
1 Make sure the switches and the ties are in working order
2 make sure the glutinosity of the bottom of the protection block
is good for fixing.
3 make sure the alarm of the 15921N is normal
For replace the cell:
When the alarm of the 15921N is undertone or can’t be stopped by EG-RC600,
or the 15921N can’t make the 15901R alarm, please replace the cell in
it:
1 open the crust of the 15921N and replace the cell in it
2 make sure the 15921N work normally and can make the 15901R alarm
3 envelop the crust of the 15921N
Caution:
Any changes or modifications not expressly approved by the party
responsible for product compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.