User's Manual

（V1.0）
11
6.3. Troubleshooting
In the operation of this equipment, if feeling it wasn’t work well, please refer to the following questions
and solutions. If this can’t solve the issue, please contact with vendors or service providers.
Issue reason of the malfunction Solution
Can not boot
1 、 The battery no
electricity;
2. the on/off switch is not
placed well;
1.recharge the machine, over
around 15 minutes and then
switch on.
2. Check if the switch was put at
“ON” place.
RF can’t be
connected after a
long time light
blinking
1. Receiver Inserted
correctly or not, the
inserted device is in boot
state or not.
2. The signal is too weak
at your physical location,
or there is a wireless
interference.
1. Check if the receiver inserted
correctly and the inserted device
in the boot state.
2. Move your location, make sure
there’s no interference between
you and the inserted device.
Operation of the
mouse pointer
jumping, or
unresponsive
1.the equipment you
connected itself is not
working properly
2. your physical location
is too far away from the
equipment, or there are
too many block between
you and the equipment.
1.Check if the operation of the
equipment has been confirmed
that its working correctly.
2. Move your location or try from
another direction.
Device can’t be
charging
1.Chargers and
equipment not being
connected well;
2.Battery performance
degradation.
1. Correctly connect the charger
to this device;
2. Replace the same model
batteries; please contact your
local dealer.
6.4. Packing list
This equipment package contains the following items, depending on the local dealers:
Configuration Units Amount
Wireless combiner PCS 1
Wireless receiver PCS 1
Charging Data Cable PCS 1
User Manual PCS 1