Installation Instructions

when the module is installed inside another device, the user manual of this device
must contain below warning statements;
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that
comes with the product.
Any company of the host device which install this modular with limit modular
approval should perform the test of radiated emission and spurious emission
according to FCC part 15C : 15.247 and 15.209 requirement,Only if the test result
comply with FCC part 15C : 15.247 and 15.209 requirement，then the host can be
sold legally.
The FCC rule/s for this module are CFR 47 Part 15 Subpart C.
This modular transmitter is only FCC authorized for the specific rule parts listed on
its grant. The host product manufacturer is responsible to any other FCC rules that
apply to the host not covered by the modular. transmitter grant of certification. The
final host product will require Part 15 Subpart B compliance when the modular
transmitter is installed.
The module may be operated only with the integral chip antenna with which it is
authorized.
Additional testing and certification may be necessary when multiple modules are
used.
Any modifications made to the module will void the Grant of Certification, this
module is limited to OEM installation only and must not be sold to end-users, end-
user shall have no manual instructions to remove or install the device, only
software or operating procedure shall be placed in the end-user operating manual
of final products.