THANK YOU! We are grateful that you chose our two way radio. We believe this Two Way Radio will provide dependable and reliable communication to personal operating at peak efficiency. The transceivers incorporate the latest in advanced technology.
CONTENT Supplied Accessories snr n ssn eee, 01 Getting start r-rremrereem ree 01 Charging Precautions ssn nce 02 Basic Operation and Function Description 02 0 E01 Technical Specifications sere 05
Supplied Accessories Enclosed Accessories Quality Two Way Radio Li-ion Battery Pack Belt Clip Strap Micro-USB User's Manual tea en fas Two Way Radio dan Battery Belt clip Strap Micro-USB | User's Manual Getting start Power Switch LED Indicator Speaker Microphone
f | Interface PTT key ; 0 I Channel up gr FE Charging interface Channel down Charging Precautions Take out the charger, and then plug it into the AC power. Using the output plug into the transceiver charging jack. In this case transceiver indicator light blue(see radio's bottom). After charging full, the indicator is shown below) Basic Operation and Function Description Power Switch Continue Press " &” button, radio switch on. Press this button * &” again more than 28, radio switch off.
Shortly press “ * key, volume down. You will hear the "beep" tone. Short press key switch{under the main volume mode}. Shortly press " + " key, to increase channel number. Shortly press " ” key, to decrease channel number. Key lock Press the “ “for 2s enter the key lock mode, press ““ the for 2s again out of the key lock mode. Monitor Function Press the “ + * for 2s, Run on Monitor, Release the * + "close the Monitor.
Warnings RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE FOR PORTABLE TWO-WAY RADIOS Before using this radio, read this guide which contains important operating instructions for safe usage and RF energy awareness and control for compliance with applicable ATTENTION! | Standards and regulations. This two-way radio uses electromagnetic energy in the radio frequency (RF) spectrum to provide communications between two or more users over a distance. RF energy, which when used improperly, can cause biological damage.
your two radios, please contact the local government radio management departments. Use of this radio outside the country where it was intended to be distributed is subject to government regulations and may be prohibited. Unauthorized modification and adjustment Changes or modifications not expressly approved by the party responsible for compliance may void the user's authority granted by the local government radio management departments to operate this radio and should not be made.
rive 2014/53/EU and the RHOS Directive 2011/65/EU and the WERE Directive 2012/18/EU; the full text of the EU declaration of conformity is available at the following internet address: www.chierda.com.
RF Exposure information + DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio, and the antenna gain shall not exceed the specified gain by the manufacturer declared.
Operating Instructions: = Transmit no more than the rated duty factor of 50% of the time. To Transmit (Talk), push the Push to Talk (PTT) button. To receive calls (listen), release the PTT button. Transmitting 50% of the time, or less, is important because the radio generates measurable RF energy exposure only when transmitting in terms of measuring for standards compliance.
metallic powders, grain powders, efface. » Turn off your radio while taking on fuel or while parked at gasoline service stations. To avoid electromagnetic interference and/or compatibility conflicts = Turn off your radio in any facility where posted notices instruct you to do so, hospitals or health care facilities (Pacemakers, Hearing Aids and Other Medical Devices) may be using equipment that is sensitive to external RF energy. » Turn off your radio when on board an aircraft.
cause bodily injury such as burns. Exercise care in handling any battery, particularly when placing it inside a pocket, purse or other container with metal objects Long transmission « When the transceiver is used for long transmissions, the radiator and chassis will become hot. Safety Operation Forbid +» Do not use charger outdoors or in moist environments, use only in dry contradistinctions. « Do not disassemble the charger, that may result in risk of electrical shock or fire.
\Warranty Card Product model: i. Date of purchase: Serial Number: Seller: contact number: Username: contact number: Address: Zip code: Warranty description: 1. The warranty card is saved by the customer as the warranty certificate, and the loss is not compensated. 2. This card must be stamped and dated for sale to take effect. 3. This card must not be altered. Please confirm that the warranty card serial number matches the purchase machine number, otherwise it will be invalid. 4.
