User's Manual

PRE./NEX.
Long press the VOL+/VOL- for 2s
Volume Control
Press the VOL+/VOL- to adjust volume
Entering Bluetooth
mode
Long press VOL+ button for 7s until the
voice prompt
Playback Modes
(SEQUENCE /
SHUFFLE / SINGLE
REPEAT)
Touch the Play/Pause button for twice
HANDS-FREE FUNCTION
Function
Operation
Answer/End a call
Touch the Play/Pause button
Volume Control
Press the VOL+/VOL- to adjust volume
Notice:
1. The volume and break-point will be automatically saved when powering off.
2. After power on, the Playback Mode will become default mode-SEQUENCE.
SWIMMING TIPS
1. Before wearing it to swim, remember to click the VOL+ and VOL-
button at the same time to disable Play/Pause button. After swimming,
you can also active Play/Pause button by repeating above step. You can
hear a voice prompt and see the LED flash five times after each
operation.
2. The Bluetooth signal cannot transmit through water, so please use the
MP3 during swimming.
3. Infiltrating water may block the earphone sections and reduce the
speaker volume. To restore volume, please remove the ear buds and
blow air into the headphone section to propel water out. Then squeeze
the ear buds to drain the remaining water. Reinstall ear buds so that you
can use the unit properly again.
4. Clean the remaining water on the headphone every time after
swimming. As the remaining water may cause damage to the device