Quick Start Guide Of Bluetooth Notebook Mouse V1.
Installation Step1. Inserting Batteries 1. Remove the battery cover. 2. Insert 1 AA batteries. 3. Place back the battery cover. As the Mouse has power switch, please make sure the power switch is on. Step2. Connecting the Mouse to the Dongle Before you install the Bluetooth Mouse, please make sure that you computer support Bluetooth function, and finished the Bluetooth software installation. Software available like Wincomm, IVT or the Microsoft built-in software.
B. Match on Microsoft built-in software 1. Make sure that the Bluetooth Function has been activated. Double click the Bluetooth Icon on the Task Bar or in the Control Panel, open the “Bluetooth Management” window, click “Add”, tick off “facility is ready for searching”, click “Next”. 2. Wait till the Mouse is found, select mouse, click “Next”. 3. Select “No Password”, click “Next”, the system will install the new facility automatically.
C. Match on IVT software 1. Make sure that the Bluetooth Function has been activated. Double click the Bluetooth Icon, open the Management window, select “Search for Bluetooth facilities” or click the Round Ball in the middle of the window. 2. Click the Bluetooth Mouse founded, click the right button for “Refresh Service”. 3. Select the Bluetooth Mouse again, click the right button for “ConnectBluetooth Input Service”, the system will auto install the HID facility.
Mouse Function 3D Wheel Troubleshooting 1. Before you install your Bluetooth Mouse, please make sure you have done the Bluetooth Dongle installation procedure, and the Bluetooth facility is turned on. 2. If you press the Connect Button inadvertently or some abnormal disconnection occurs during using, please reconnect the mouse. If unable to rematch, kindly delete the Mouse Icon to erase the stored info of the mouse in the computer. 3. Make sure there is no change of the Bluetooth facility.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
