Instruction Manual

WALL MOUNT INSTALLATION
INSTALLING I REM 。 YING THE BASE STAND
WARNING : The LED Display
isveryfra 日 ile. and must be protected al all times when removing the base
Stand.
Be sure that no hard or sharp object or anything that could scratch or damage the LED display comes into
contact with
it D 。 NOT exert pressure on the front of the unit at anytime because the sc 『 een c 口 uld crack.
1 . Disconnect all cables or cords connected to the unit.
2. Lay the
unit down on aflatsu 巾 ce with the back side facing up Please make sure to place e soft
cushioned mate 『 lal ( such as a pl llow or thick piece of foam) beneath the screen
3.To 「 emove the base stand, loosen screws off the holes then pu II downwa 『 dsto 「 el ease
the base stand
P 翩翩 1s""""'I 曰蛐啕
M4x18mm I 4 阳
MOUNTING ON THE WALL
This
unit is VE SA-com pliant, and is designed t 。 be wall-mounted with a VESA-compliant 8”x g ’
但 OOmm x 200mm) mounting kit designed fo 叫“－ panel TVs (not 趴 1pplied).
Length ofscrew should be not exceed 8 mm
N 。 TE
Rem 。 vethe base stand before mounting the unit on the wall.
？ …－ 8 也 ·· 哼
E 眩 ’
b …－－－－－－ 品
F 。 ur mounting hol 盹
(size MB screw)
7