User's Manual

At this time, the icon of “0” in the interface flashing, press the "+" button to
enter the matching mode.
“1” shows 00 small wheel icon flashing, and then install the sensor #1. If the
matching is successful, it will automatically enter the matching of “2”.
“2” shows 00 small wheel icon flashing and then install the sensor #2, it will
automatically enter the matching of “3”.
“3” shows 00 small wheel icon flashing, and then install the sensor #3, it will
automatically enter the matching of “4”.
“4” shows 00 small wheel icon flashing, and then install the sensor #4, it will
automatically enter the matching of “5”.
In standby interface, hold down the "+" button for 3 seconds to enter the
matching setting mode. Press the "+" button to enter the matching mode,
as shown below:
Tire Matching Setting
(Inflate/Deflate Matching):
13