Installation Instructions

Table Of Contents

φ13.8Inch

1.65Inch

Tapping Screws X 4

Flat Head Screws X 4

Anchorings X 4

Wire Nuts X 4

◆ Size:

13.8 X 1.65Inch

◆ Input Voltage： AC 100V-277V 50/60HZ

◆ Working Temperature: -20℃-45℃

◆ Beam Angle:160°

Product Parameters

2Inch

4.1Inch

2.5Inch

3.5Inch

1 2

If any problem when you install, send us email to:

serviceled@hotmail.com

Installation Instructions

Push Wire Nuts upwards

a .Use tapping screws and Anchors for solid ceiling

b .Use flat head screws for junction box

Lamp is made of insulating plastic ,so no need for ground wire

Rotate the lamp clockwise and install onto base plate ,then

finish installation !

Secure base plate

Connect the AC cables ,L /N

Rotating Lamp

LED Ceiling Light

Blue:N

Brown:L

Warning

OFF

ON-OFF Switch Dimmer Switch

√

PAGE 1
LED Ceiling Light φ13.8Inch 1.65Inch Product Parameters ◆ ◆ ◆ ◆ Tapping Screws X 4Head Screws Flat X 4 Anchorings X 4 Nuts X Wire Size:φ13.8 X 1.65Inch Input Voltage： AC 100V-277V 50/60HZ Working Temperature: -20℃-45℃ Beam Angle:160° If any problem when you install, send us email to: serviceled@hotmail.com 4 3.5Inch 2.5Inch ON OFF Warning √ ON-OFF Switch × 2Inch 4.1Inch Dimmer Switch Installation Instructions 1 Secure base plate 2 Connect the AC cables ,L /N Brown:L Blue:N a Use .
PAGE 2
Operating Guidance 4.Firstly,ensure it in state of light off,cycle lights on/off 2 times,then turn on the light,it will start blinking. (When you turn on the light, if it's blinking fast, skip the reset step) 1.Search“TuYa”at App store and install the APP (Or Scan the following QR code by your phone) 2.Log in your TuYa App (Please sign up when use at first time) START ON FINISH 1 3 5 ON ON ON OFF OFF 2 4 OFF 5.Confirm the lamp is blinking and connect to the 2.4g Wi-Fi 3.Click "Add device".
PAGE 3
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.