USER MANUAL GARDEN LASER LIGHT MODEL NO.: QS-25C It is very important to operate this product according to the following instructions. Failure to do so may render your guarantee void.
A. A. B. C. D. E. F. G. H. I. J. B. C. D. E. F. G. H. I. J Power ON/OFF Choose any 1 from 8 Patterns 8 Patterns Cycling(20s for every one) Laser Light Blink Alternately Only Rotating or Blink Speed – Laser Light Rotating Rotating or Blink Speed + Laser Light Static Red Laser Light ON/OFF Green Laser Light ON/OFF SPECIFICATIONS: ● Power Input: AC120V 60Hz/50Hz ●Power Output: DC 5V 2000mA ● Spike height: 7.79 in.
Quick Setup 1. Remove all the components from packaging and saving packaging to store laser light when not in use. Please make sure that there are 1x Laser Light, 1 x Screw, 1 x Bracket, 1 x Stake, 1 x stand, 1x Adapter, 1x Remote Control and 1 x User Manual in the packaging. 2. Install the laser light: 1 )Find a location where is no obstructions between light and its projecting surface for the laser light. 2).
A B D C E Built-in Timer The device is designed to automatically shut off after 6 hours lights working in the dark, and it will go into sleep mode for 18 hours and repeat the same operation thereafter. IMPORTANT SAFETY INSTRUCTIONS 1. No recommended for set-up or installation by children. As with all electrical products, exercise caution during handling and use to reduce the risk of electric shock.
12.This product was designed for indoor and outdoor use. 13. This seasonal use product is not intended for permanent installation or use. 14. Unplug the product when leaving the house, then retiring for the night, or if left unattended. IMPORTANT Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for any resulting defects or problems.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with 21 CFR chapter I, Subchapter J, CFR1040.10 and 1040.
