User's Manual

ManualsBrandsShenzhen Qianhai LIVALL IoT Technology ManualsElectronicsSport Helmets

User Manual

SPORT HELMETS

Model:BH100

I. Introduction

This smart safe-riding helmet (hereinafter referred to as “bling helmet”) is made of the lightest and

safest materials, which makes it more comfortable and safer. Its fine ventilating structure inside

enables air to flow smoothly through so as to achieve the best cooling effect. It also has Bluetooth

speaker, smart outline lighting and warning tail light.

Warning tail light

Bluetooth speaker

Button “+”

Charging port Button “□”

Button “-”

II. Packing list

One helmet one hag tag

One USB charging cable One warranty card

One product instruction

III. Wearing instruction

Usage:

This safety helmet adopts a fixed setting, easy to operate, putting on or taking off the helmet only

with the buckle. Flatten the drawstrings on both side and make them clinging to your face,

buckle up it when the helmet is tightly putted on. If the drawstrings become loose, please take off

the helmet and adjust them properly. When adjusting the drawstrings, please use one hand to fix

the buckle and then adjust the drawstrings within proper tightness. If you want to strengthen the

Summary of content (6 pages)

PAGE 1
User Manual SPORT HELMETS Model:BH100 I. Introduction This smart safe-riding helmet (hereinafter referred to as “bling helmet”) is made of the lightest and safest materials, which makes it more comfortable and safer. Its fine ventilating structure inside enables air to flow smoothly through so as to achieve the best cooling effect. It also has Bluetooth speaker, smart outline lighting and warning tail light. Warning tail light Button “+” Charging port Button “□” Bluetooth speaker Button “-” II.
PAGE 2
rear drawstring, pull it tight from its back, use one hand to fix the helmet and another one to fix the drawstring under the chin and adjust the four drawstrings to a most appropriate position. Front Brim Front drawstring Buckle Rear drawstring Adjustment buckle Back Proper wearing The helmet must be worn closely to your head.
PAGE 3
Checking Make sure that the helmet must be put on your head correctly and firmly . Readjust the tightness of the drawstrings to a proper position if the helmet still shakes. For the best protection effect, please make sure that the helmet is suitable for you and could be tightly wore. Check the adjustment again every time you wear to ensure that the helmet could be closely put on your head. IV.
PAGE 4
port. When it’s connected, the two indicator lights in the middle of the tail light would flash red (no such indicator under normal standby state) and green when the charging is done. The electricity of the charger is suggested to be > 1A and the charging time about 3.5h. Factory Reset: Hold “□” till the outline light shows white, and about 20 seconds later, the white light would automatically fade away and the product is reset. V.
PAGE 5
3. After start up, it automatically powers off after a short period of use (maybe the battery is low) 4. After unplugging the charging cable, the charging light is still on and rebooting could not fix it. 5. Start up is normal, but the speaker has no notification sound or has just single tone or noises. Trouble shooting steps 1. Charging for 1 to 2 hours 2.
PAGE 6
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.