User's Manual

10 11
Installation
1. Use the unit to determine the best mount-
ing location and to mark screw holes.
Note: The mounting location
needs to be a flat surface.
2. Drill pilot holes for the screws.
3. Mount the entertainment center using the
provided screws. Make sure to tighten the
screws equally to create a waterproof seal
Wiring
Installing Wired Remote (Optional)
1. Install mounting studs into rear of remote con-
troller. Hand tighten the studs only.
2. Cut a 2-1/8” hole.
3. Insert cable from remote controller through the
hole and then mounting bracket.
4. Slide mounting bracket onto mounting studs.
5. Screw the wing nuts onto the studs and hand
tighten them against the mounting bracket.
Do not use pliers to tighten the wing nuts.
Note: If the surface is uneven like wood, use
silicone to create a waterproof seal between the
uneven surface and the remote control.
Mounting
Studs
Wing
Nuts
Mounting
Bracket
Cable
External Automotive
Type Antenna
(Optional)
White/Black Wire
Left
Front
Speaker
White Wire
Gray/Black Wire
Gray Wire
Right
Front
Speaker
Right
Rear
Speaker
Violet/Black Wire
Violet Wire
Green/Black Wire
Green Wire
Left
Rear
Speaker
Blue Wire Trigger for Amp (+12VDC output)
Black Wire Ground
(+) to 12 Volt Battery
10 Amp
Fuse
ENT
SEL
MENU
VOL
VOL
MODE
Wiring Harness
Model: SPA-HAR
(Sold Separately)
Red Wire
A
(Front)
B
(Rear)