ise Ln ELBE nl Ee ae User Manual Pro scenic Technology Co, Ltd, E-mail: en Lease keep this user manual in your sight, read it thoroughly and carefully before using this product.
label of Contents Packing list 1 Product description 2-5 Installation notes 6 Instructions for use 7-10 Routine maintenance 11-17 Basic parameters/ Troubleshooting 18 Common problem 18 Security Information 20 FCC Statement 21
| Product description Host {1 Start/Stop Button « Extended press to tum on /Short peers to turn off Stertorous cleaning {y Recharge button Short press to atart/pauss recharging Valid blue light: Normal working/pause/ standby Bite fight flash: is powering concurring network/upgrading firmware Yellow light flash: low hattery/recharging Green light Rash: charging Solid green fight: Fully charged Red light flash quickly: Abnormal Error Light off: Off faceless Network Configuration While the power Is on, press a
| Product description Host and sensor Lear ranging 1 sensor IN = Bastion Speaker eo Infrared leprechaun-cuilislon extrasensory Wail-mounted TOF sensor / Infrared Natl-collision sensor auxiliary recharge sensor mma Laser shad .
I Product description Host and sensor Right sleds brush Sett drive whereas Calling-Brush Charging base ~o Indicator fight Signal emitting area -s Charging pole piece Front of the charging stand Charging pole piece Universal whereas Left side brush CUT sensor Left drive was! Middle sweep cover “The back of the charging stand
| Product description Dust box assembly water tank Reassure button button Dust box bucks a Dust box release *fitter of Waiter tank = Dust box release button
| Installation Notes Installing the charging stand Connect the power cord and the charging stand is placed against a wai on a flat surface. Against the wall Net against the wall * Make sirs that thees is mots than 1.2 meters in front of the charging stand and more than 0.6 meters in the sift and right sides to ensure a smooth back fill. * Do not place the cradle in direct sunlight.
| Instructions for use Power on/off Press and hold the * 1) * button to power on, and the host enters the standby state. After hooting, press and hood the * (1 * button to shut down. Note: When the host Is charging on the charging stand, it wii automatically tum on, and it cannot be muted off during charging. Start/pause Under the power on state, short pass the “(4 button to start the whole house gleanings, Press any key to pause wheels cleaning.
| Instructions for use Connect to the mobile client @ The fens Is connected to WIFE Add device on the home page choose sweeping robot” M7 PRO”; |e) @ Select the connected WIGHT of the phone ane enter the WIFE password; D Return te the APP and wait for the distribution artwork tn complete.
l Instructions for use Emote control Recharge button Arrow key Startups button Mopping mods Spot cleaning Mute button Gear reduction Bear plus Max button Neo: 1. To ensure cremate control effectively, It 1s recommended to use it in the front area of the main body; 2. The effective distance of the remote control le 8 meters.
| Instructions for use Water tank If you dean to mop the floor, you can use the water tank. Note: Do not mop the floor on the carpet to avoid wet carpet.
| Routine maintenance Dust box and filter assembly {recommended weekly) (D Press the dust box reassure button to remove @ Open the dust box, and dump out the garbage the dust box; @ Open the dust cover and removal the filter @ Stake off the trash on the filter net and use a cleaning brush such as HEAP and sponge; to clean the dust box and filter; 1
| Routine maintenance B After filing clean warts Into the dust bok, shut off the @ After drying the filter and dust box, replace the filter dust box and shake It to the left and right, and pour out and dust box. the dirty water.
| Routine maintenance @ Pour out the remaining water in the water tank and dry the water tank; ® Filter of Water tank if the amount of water Is small or does nat produce water, It Is recommended to replace the tank filter. 1. Pull out two ald fitters; After the rag and water tank are dry, put it back for use; 2.
| Routine maintenance Main brush (recommended weekly) @) Tum the men unit, peers the left and Eight buckles, snd remove the middle sweep cover; 2 Remove the roller brush upwards and clean the entangled hair and rubbish with a cleaning brush; 2 Replace the roller brush and Insert the tees legs of the middies sweep cover Ito the slot, press down and fix the buckle. Note: Depending on the appellation, It Is recommended to replace the main brush for 8-12 meths to ensure the cleaning effect.
I Routine maintenance Side brush {recommended weekly) @ Use a screwdriver to sorrow the 2 aide brush screws and remove the 2 side brushes. @ After cleaning the wrap hale and rubbish on the side brush, carapace the side brush.
| Routine maintenance Host and sensor {recommended monthly) Wipe the sensor on the main unit with 2 soft, dry cloth, including: (D4 cliff sensors at the bot torn of the main unit @ Wall sensor on the right side of the host @ Infrared auxiliary recharge sensor @ Charging pole at the bottom of the main unit —e Charging pole place Wii-mounted TOF *— sensor { infrared auxiliary chargers sensor infrared auxiliary recharge sensor 18
| Routine maintenance Charging stand {recommended monthly) Wipe the charging pols of the charging stand with & soft, dry cloth, Universal wheel {recommended monthly cleaning) @) Flip the main unit end pull out the universe! whee! upwards; @ Clean the hair end dust on the wheal, axis and support; 3 Reinstall the universal shew! snd press i tight. Soto: Wash with water, dry it and pot 1t back.
Basic parameters Host Charging stand Nam Parameters Dimension 148m] Admissible Dimensions $350mimx$350mmxS8mm Rated power 30W Product weight =3. Bkgy Rated input 24¢ 1.24 Rated voltage 14.4V— Rated output 24Y 1.24 Rated prows BOW Battery capacity 5200mah Troubleshooting Fault prompt Solution Abnormal 1. Pie ass confirm that the laser darer fs not blocked Please shack or remove foreign objects around the liar or move the device to a new location to restart Abnormal 2.
| Common problem Question type Solution Can not boot The battery is low, please charge it before using Lambent temperature Is too low {lees than high {higher than 50°C} Unable fo start cleaning “The battery Is low, pleads charge It bettor starting Anubis to recharge There ars too many obstacles near the charging stand. Pleads put the charging stand in e open area The host Is too far from the recharge seat.
I Security Information Use limit » This product Is only used for floor cleaning In the home environment. De not usa It outdoors (such as ops balconies], non-ground (such as sofas), commercial or industrial environments, such as men-ground {such as sofas), commercial or Industrial environments. + Do not use In environments where there fs gull or viscous material above 40°C, below 0°C. » Do not use or operate this product Tor people with physical, mental or cognitive impairments, including children.
| FCC Statement 1. This device complies with Part 15 of the FOC Rules, Operation ls subject to the following twe conditions: {1} This device may not cause harmful Interference, and {2} This device must accept any Interference received, including Interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could cold the user's authority to operate the equipment.