Important Safety Instructions A WARNING: TO REDUCE THE RISK OF INJURY OR DAMAGE, READ THE FOLLOWING SAFETY PRECAUTIONS WHEN SETTING UP. USING, AND MAINTAINING YOUR ROBOT. THIS APPLIANCE MAY ONLY BE USED BY CHILDREN AGED 8 YEARS AND ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY, OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE HAZARDS INVOLVED.
If the room to be cleaned has a balcony, a physical barrier should be used to prevent access to the balcony and ensure safe operation. Do not place anything on top of your robot. Be aware that the robot moves on its own. Take care when walking in the area that the robot is operating in to avoid stepping on it. Do not operate the robot in areas with exposed electrical sockets in the floor. A WARNING Shock Hazard: Your robot comes with a region approved power supply cord.
A WARNING Fire or Explosion Hazard: Do not crush or dismantle battery packs.Do not heat or place the battery pack near any heat source or in direct sunlight. Do not incinerate or short circuit the battery pack. Do not subject batteries to mechanical shock. Do not immerse the battery pack in any liquid. Contact your local waste management authority for more information on battery recycling and disposal regulations in your area.
Product introduction Key Buttons Robot cover Power Button Short press tio power convoy the robot WIFI indicator dash Tastily: wil connecting oli it: wif connected Power Indicator Power stale green light Costar <20%: red it blinks Recharge Button Press Ito star charging mode Clean Button Eras to start clean ) ON/OFF Network Configuration Ho operation for 10 mines / press and hold it for 3 Press and hale seconds fo chant network seconds fo refer sitemap mode configuration Crass to stop cleaning Main Body «Inf
Product introduction Mopping Module Infrared signal emitting area Charging Contact Points Water Tank Fitter Element Stickup Area Neo Water Filling Water-Tank Nozzle Buckles Charging Indicator DC Plug Remote Control Power Button WiFi Mute Direction Button Pause/Start Suction Strength Clean Mopping Fraught Fan dose not work) , Recharge Proscenium N— —05 —
Main Body and Accessories Main Body*1 Side Brush*2 HEAP Filter*1 oo 6 Manual*1 Water Tank*1 Charging Base*1 Remote Control*1 {dust bin included} Filter Elements*4 adapter*1 Product Operation 1.Docking station placement 2.Press # on robot or 4: on remote control to Place docking station against the wall and remove operate the robot to go back to the charging obstacles from within 0.5 meter at two sides and station for recharging as shown in Figure.b. about 1.
Giselle e101 3.APP installation Please download APP“ProscenicHome” by caning the QR code or In Google Play or App Store. After the spp installation, please folio the APP prompts to enter network configuration. With APP, you can gat mots robot function after connecting the robot wife, Tha robot ls not compatible wih 50h network.
@ Uncap the water tank, Till i with water, and fasten the rubber cover. Some disinfectant of detergent may cog the tank filer @ As shown in the figure, push the mopping module horizontally into the bottom of the robot Please make sure the buckles on both sides are installed properly. Press the buckles on both sides of the mop module to remove the mopping modules. Praises remove the mopping modulo whe chastity or not In service Pause / Resume Clean 1.
Area Cleaning Press and hold the recharge button on the robot for 3 seconds. Centering on the start point, the robot cleans in a square area of 2m*2m. Robot Vacuum faiaOFiiviafeen Save Vacuum Suction Strength Choose quiet, standard, or strong mode by app of remote. control. The default ls standard mode.
Map Rebuilding 1.Robot builds a new map when it starts in a strange area. 2.A great change of the indoor home environment will cause the positioning fail, and hence the robot rebuilds the navigation map. Rebuilding the map will result in the loss of settings made on the original map (including the Off-Limits Area). DND mode) During the DND pried, the robot does not automatically resume work and actively play the voice.
Product Specifications HOST Classification Parameter Dimension 320mm” 300mm ST mm Weight 3.5kg Power Rating 14.4 Rated Power 46.08W Working Current 324 Charging Base Dimension 152mm 100mm»47mm Output Rating 14.4W Rated Input 100-240V~ Rated Output 24 —B00mA Input Frequency 50/60Hz Trouble Shooting When an abnormality scours during the running of the robot, the Clean button or the Recharge button fisherman voice prompts. Please refer to the able below for troubleshooting.
Clean bunion finks: k wil slowly blink three mes then quickly flash The side brush is entangled with garbage. 8, Please clean the side Please disassemble the side brush and clean if; brush once 7, Please clean the main Clean button blinks: i will slowly The main brush may be entangled with garage. brush blink once then quickly flash once Pleads remove it and its bearing to clean. 8, Please place the robot on the ground to start The wheels are suspended. Please place the robot on the ground io start.
Questions Solution Cannot return to the charging base after partial cleaning or being moved Please manually place the robot in the charging stand. fo another position If you can not connect robot io your phone, pleas refer to the following list for troubleshooting: 1. Plsass make sure that the WIF! password is entered correctly. 2 Please confirm whether the WIFE is 2.4G; If the home router is a dual-band router, pleads sst the SAID name of 2.4G and 5G separately. 3.Please close the 4G traffic when binding.
