User's Manual
85*65mm
1:1
无线充电器说明书
TB30
中性
/
/
128g哑粉纸 双面四色印刷
2020/3/5
Standby Light keeps green
Charging Light keeps blue
The wireless charging indicator light flashes green and blue altern-
ately, 2seconds later both blue and green lights on at the same time,
then the green light on for standby.
V 5.0
Rated Power of Bluetooth Speakers 5W*2
Bluetooth Speaker
Indicator Light
Power Switch
Long Press Reset/Short Press To Disconnect
Bluetooth Pairing Or Connect Radio Mode
Pause/Play
Long Press, Volume Down
Short Press, Move Previous Song/
Previous Radio
Long Press, Volume Up
Short Press, Move Next Song/
Next Radio
TF Card Slot
AUX Input
Wireless Charging
Indicator Light
Mobile Phone
Support Plate
Power on
Charging light keeps red
Fully charged light keeps green
Waiting for connection Green light flashes.
Connected device Light keeps green
TB30
Type-C Charging
Input
Battery Charge
Indicator Light
Wireless Charging
Bluetooth Speaker
Fully charged
The light will turn to green when fully charged, except when charge
iPhones. (The light will not turn to green when the iPhones fully
charged.)
Error report Blue light flashes.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception,which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body:
Use only the supplied antenna.
FCC ID:
2AFP2TB30