User's Manual

21
@1500W/100Vac , @1800W/120Vac Max .
The charging process will automatically stop when it reaches 100% capacity.
receptacle, the maximum charging power allowed will be up to 3000W.
Charging via wall outlet
Charging via Sub Panel
Main
Panel
Sub
Panel
8.1.2. Charging Method 2: From Generator (gasoline, propane, or diesel)
Connect the EP500Pro from CP1 via the generator charging cable (sold
spearately) to the AC output of the generator. The charging process will
automatically stop when it reaches 100%.
The required output power of your generator has to exceed the Max. input
power of the AC input port of the EP500pro. Also a generator with a pure sine
Voltage limit:
Frequency limit: 63Hz(60Hz).
(Charging via Generator)
22
8.2. CP2 (2
nd
Charging Port)
8.2.1. Charging Method 3: Solar Panels (via 4pin aviation-MC4 cable)
For regular solar panels:
EP500Pro(dual MPPT) supports two PV charging methods with regular
portable panels and rigid panels.
Max current for single circuit: 12A.
Max. Input Power: 2400W.
Note: Select DC1 or DC2 Input Source according to the the certain DC
cables(check the label on cable No.3) you are connecting.
1 2 3 4
1
2
2
3
3
4
1
( Easy steps to solar charging )
23
For Roof/Rigid Panels:
If you choose roof panels to be the solar power source to recharge EP500Pro,
PV Module (additional accessories) is required to drop down the voltage if
the open circuit voltage produced by your roof panels exceeds the limit of
microinverters, and open circuit voltage over 550V.
instruction video.
a.DC Output Cable to EP500Pro
b.DC1 poles to PV1 poles
b
a
c
d
a
b
c
d
( PV Step Down Module )
c.DC2 poles to PV2 poles
d.DC Output Cable to D300S
8.2.2. Charging Method 4 :Vehicle Charging
Turn on EP500Pro.
Connect car charging cable with MC4 to Aviation cable(cable No.3)
Plug the car charging cable into CP2 and the cigarette lighter port on your car.
Note: Select DC1 or DC2 Input Source according to the the certain DC
cables(check the label on cable No.3) you are connecting.
24
8.2.3. Charging method 5: Lead-acid Battery Charging
Connect to the positive and negative poles of the battery through the battery
charging clamp(pay attention to distinguish the positive and negative poles of
the battery, the red pole on battery indicates the positive pole, and the black one
for negative pole).
Note: Select DC1 or DC2 Input Source according to the the certain DC
cables(check the label on cable No.3) you are connecting.